Nussbaum WA 900 Instrucciones Para Puesta En Marcha página 40

WA 9xx:
Turn on screen
WA 9xx from FD 04/03 onwards
Socket outlet with ground contact at the
support steel
4 0
Monitor is turned on automatically after
switching on the wheel alignment system
via the power switch.
Then, the green operating light at the moni-
tor illuminates. If there is no video signal, the
LED will flash in yellow.
It is possible to connect corresponding
measuring devices via the socket outlet with
ground contact for service purposes.
There is no voltage present at the power
supply unit cartridge:
Power supply unit cartridge must be re-
placed.
Printer does not print although a voltage
is applied:
Initiate a repair or an exchange of the printer
via the Nussbaum customer service.
Printer does not print cleanly:
In case of problems, a Lexmark Z25-Z35
must be called with the red mouse key via
ControlPanel/Printer/PDR U02.
Operating light does not illuminate:
Screen has not been switched on.
Screen has been switched on, but opera-
ting light does not illuminate:
Check whether there is a voltage supply at
the screen and whether the cable has been
connected properly or whether it has been
connected to the device at all.
If it is not possible to turn on the screen in
spite of this, a replacement via the Nuss-
baum customer service must be initiated.
There is no voltage present:
Check the wiring and re-measure the voltage
between L, N and PE.
22.01.04 1 689 975 177N