Standard Operation; Operating With A Somfy Sensor - SOMFY Sonesse 50 RTS Guia De Instalacion

6. OPERATION

6.1. Standard operation

up, down, My
1) To move the shade from a limit to the other limit,
briefly press the UP or DOWN button.
2) To stop the shade, press the MY button.
3) To move the shade to the MY position, briefly press
the MY button.

6.2. Operating with a Somfy sensor

6.2.1. Operating with a Somfy sun sensor
To activate this function, you need a Telis Soliris
transmitter. By default, the Sun function is not active.
1) To activate the Sun function, press the SELECT
button on the Telis Soliris transmitter until the shade
jogs.
2) To disactivate the Sun function, press the SELECT
button on the Telis Soliris transmitter until the shade
jogs.
When the intensity of the daylight exceeds the
threshold set by the Sunis sensor RTS, an order is
sent to the shade after 2 min.
The shade goes to the MY position or to its down limit
if no MY position has been memorised.
When the intensity of the daylight falls below the
threshold set by the Sunis sensor RTS, the shade goes
to its Up limit after a delay of 15 to 30 minutes.
6.2.2. Operating with a Somfy wind sensor
Reaction of the screen to the wind rising.
When the wind rises, the screen will start to move up
to the upper end limit. It is impossible to prevent the
screen from closing, or to lower it while the wind is still
blowing.
Reaction of the screen to the wind dropping.
When the wind has dropped, a manual down order
may be issued via the RTS control point after 30
seconds. However, all automated systems will remain
locked for 11 mins.
We suggest not to pair a wind sensor to the motor
when used to motorize interior window coverings. The
motor will react in priority to the wind sensor orders,
functionning not adapted to interior window coverings.
8
1
2
3
off on
off on
© 2013 Somfy SAS. All rights reserved. 12/2013
1
off on
2
off on
30 s
30 s
OK