Preliminary Installation Operations; Preparing Electrical Connections - Aprimatic FORTY 5500 Serie Instrucciones Para La Instalación Electrica, El Uso Y El Mantenimiento

2.

PRELIMINARY INSTALLATION OPERATIONS

2.1

Preparing electrical connections

!
Warning
The system must only be installed by skilled personnel qualifi ed in compliance with the regulations
of the country of installation (CEI 64 - 8 / EN 60335-1... standards)
The metallic components of the structure (i.e. the gate and pillars) must have an earth connection.
• Prepare the electrical connection of the controller
and safety devices in accordance with the lay-out in
Fig.5. Please heed the warnings provided in this
manual and comply with the instructions attached to the
installed components. Prepare the cableways (external
or buried) up to where the devices will be installed.
• The electric component
be placed at least 30 cm from the ground. Cable outlets
should point downwards. The cableway joints to the box
should be sealed to prevent the entry of dampness, insects
or small animals.
• Always separate low voltage accessory cables from the
230V power supply.
1
control unit
1
operator
2
antenna 433.92 MHz
3
fl ashing light
4
photocell pair
5
key switch
6
OPTIONAL control devices
7
(Proximity reader ; Magnetic card reader ; Electronic keypad)
electric lock (
8
OPTIONAL
remote control
9
FORTY 5500
box is fully sealed and should
4
3
5
2
c
d
!
e
b
a 230 VAC
6A
lc= 30mA
)
OPERATOR FOR SWING GATES
• POWER SUPPLY: 230V AC
section); the cable cross-section should be calculated in
accordance with the length of the line.
If it is necessary to use automation power supply cable
sheathing, apply this sheathing before connecting the cable
itself to the derivation boxes.
• IMPORTANT! Always install, upstream of the line, a mains
switch which guarantees a multipole cut-off with minimum
contact opening of 3 mm (connect it to a 6 A differential
overload switch - sensitivity of 30 mA).
• The command and control accessory devices and the
emergency button should be placed within sight of the
automation, away from moving parts and at a minimum
height of 1.5 m from the ground.
fi g. 5 - Preparation of the electrical layout
2
8
g
9
a
2 x 1.5 mm + earth
2
b
3 x 1.5 mm 2 + earth
c
supplied cable
d
2 x 1 mm
2
e
transmitter 2 x 0.75 mm
f
3 x 0.75 mm
2
g
2 x 1.5 mm 2
- 15 -
2
- Cable 3x1.5mm (minimum
5
7
6
f
ti
f
e
b
; receiver 4 x 0.75 mm
2 2