Changing The Device Settings - KaVo Kerr elements e-motion Instrucciones De Uso

▶ Plug the power supply into the socket of the elements e-motion.
▶ Connect the power cable first to the power supply and then to the supply
mains socket.
▶ Route the cords appropriately such that there is no kinking.
▶ Affix the cord with cord ties and/or cord tape.

5.2 Changing the device settings

▶ Tap the "Lock" control element to unlock settings.
▶ If the settings are unlocked, press the control element, "Settings", to start
the "Settings" menu.
▶ Press the arrow control keys to select the various parameters.
▶ Press the Plus control element to increase a value.
or
▶ Press the Minus control element to decrease a value.
ð
The settings are always saved instantaneously.
▶ Press the "Back" control element to exit from the "Settings" menu.
The following device settings can be changed according to need and/or dis-
played when the device is being put into service.
Display information
Instructions for use elements e-motion Dental Motor
5 Startup | 5.2 Changing the device settings
Setting
The LUX brightness can be adjusted between 0 and
4. "0" means that the LUX light is switched off. De-
fault (factory setting) = 0
The LUX afterglow time of the straight or contra-
angle handpiece can be adjusted between 0 and 9
seconds. "0" means that the LUX light does not af-
terglow.
27 / 55