Selecting A File Sequence; Selecting Files; Defining/Changing File Sequences In The File Editor - KaVo Kerr elements e-motion Instrucciones De Uso

6.4.5 Selecting a file sequence

▶ Select the file sequence using the "File sequence" selection list by pressing
the desired file sequence (presently KERR ROTARY FILES).
ð
The display shows the selected file sequence.

6.4.6 Selecting files

Each file sequence has up to 10 files (1 to 10) assigned to it. Usually, these 10
files are used in sequence proceeding from 1 to 10 depending on the indication.
▶ To select a file, press the short name (or geometry) of the file on the right
selection list and move the selection list up or down, if needed.
ð
The selected file is shown with a white background, presently: K3.

6.4.7 Defining/changing file sequences in the file editor

The user can compile individual workflows by defining file sequences in the file
editor. Up to 5 different file sequences with 10 files each can be defined. Files
from different file systems can be combined in a file sequence.
The device contains a total of 5 sequences, 4 are pre-configured sequences and
1 sequence is not configured. All of the 5 sequences can be adapted by the
user.
The following sequences are pre-configured:
▪ Kerr TF Adaptive
▪ Kerr Rotary Files
▪ Kerr M4 Safety
▪ Kerr Traverse
▶ To open the file editor, tap one of the file sequences to display the selection
list of the file sequences.
Instructions for use elements e-motion Dental Motor
6 Operation | 6.4 Operating the elements e-motion
35 / 55