Setting The Speed; Setting The Torque - KaVo Kerr elements e-motion Instrucciones De Uso

Reduction ratio of con-
tra-angle handpieces
1:1 (M20 L with L68 B)
1:1 (S20)
1:1 (S20 S)
3:1 (M20 L with L66 B)
8:1 (ENDO S81)
Activated values are shown with a blue background and can be changed.
Deactivated values are shown with a grey background.
▶ To change a value with a grey background, activate the value by touching
it.
▶ Once the value is activated, use the slider to set the value.

6.4.1 Setting the speed

Note
Changes of speed or torque are not saved permanently and are available
only until the user exits from the view. In order to save the speed or torque
permanently, the speed or torque need to be set in the file editor.
See also:
2 6.4.7 Defining/changing file sequences in the file editor, Page 35
File "TF" has, e.g., speed 500 rpm (min
▶ If the torque is active, activate the speed by touching the speed value.
▶ Tap the "Lock" control element to unlock settings.
▶ If the settings are unlocked, pull the slider to the right or left to change the
speed.
If the set speed differs from the recommended value of this file, a crossed-out
factory symbol is shown.

6.4.2 Setting the torque

Note
Changes of speed or torque are not saved permanently and are available
only until the user exits from the view. In order to save the speed or torque
permanently, the speed or torque need to be set in the file editor.
See also:
2 6.4.7 Defining/changing file sequences in the file editor, Page 35
Instructions for use elements e-motion Dental Motor
6 Operation | 6.4 Operating the elements e-motion
Torque of the file
0.1 – 2.0 Ncm
0.5 – 5.0 Ncm
1.5 – 6.0 Ncm
) assigned to it.
-1
31 / 55
Minimum/maximum
attainable torques
0.1/2.0 Ncm
0.45/5.0 Ncm
1.2/6.0 Ncm