Battery Charger - SWM OUTLAW Manual De Instrucciones

BATTERY
The sealed battery does not require any mainte-
nance. When electrolyte leaks, or other failure of
the electrical system is detected, apply to the SWM
Dealer.
If the vehicle remains unused for long periods, it is
recommended to disconnect the battery from the
electrical system and store it in a dry place.
- After an intensive use of the battery, it is advis-
able to carry out a standard slow charging cycle
(12V-14Ah battery: 1.4A for 10 hours).
- Quick charging is advised only in situations of ex-
treme necessity since the life of lead elements is
drastically reduced by such cycle (12V-14Ah bat-
tery: 2.5A for 2 hours).
EN - 48

BATTERY CHARGER

To gain access to the battery (1):
- Remove the left-hand side panel.
- First remove the BLACK negative cable (2) and
then the RED positive cable (3) (when refitting,
first connect the RED positive cable and then the
BLACK negative cable).
- Undo the two screws (4) that fasten the fuse sup-
port bracket (5).
- remove the battery (1) from its housing.
Check, using a voltmeter, that battery voltage is not
less than 12.5 V.
If it is not so, the battery needs to be charged.
Using a battery charger with a constant voltage,
first connect the RED positive cable to the battery
positive terminal then the BLACK negative cable to
the battery negative terminal.
The voltage reaches a constant value only after a
few hours, therefore it is suggested NOT to meas-
ure it immediately after having charged or dis-
charged the battery.
Always check the battery charge before reinstalling
it on the vehicle.
The battery should be kept clean and the terminals
coated with grease.
3
1
2