Abicor Binzel ROBO WH Serie Instructivo De Servicio página 49

WH and WHPP
12 Disposal
12.1 Materials
12.2 Consumables
12.3 Packaging
NOTE
• Observe the information given in 8 Putting out of operation on
page EN-20.
1 Disconnect the hose assembly from the wire feed.
2 Remove the parts to be disconnected (changeable body, CAT robot holder,
torch neck).
For disposal, the local regulations, laws, provisions, standards and guidelines
must be observed. For the welding torch system to be properly disposed of, it
first must be dismounted.
 See 11 Dismounting on page EN-24
This product consists for the most part of plastics, steel and non-ferrous metals.
Steel and non-ferrous metals can be molten in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are marked in
preparation for sorting and separation of the materials for later recycling.
Oils, greases and cleaning agents must not contaminate the ground and not
enter the sewerage. These materials must be stored, transported and disposed
of in suitable containers. Please observe the relevant local regulations and
disposal instructions of the safety data sheets given by the manufacturer of the
consumables. Contaminated cleaning tools (brushes, rags, etc.) must also be
disposed of in accordance with the information provided by the manufacturer
of the consumables.
ABICOR BINZEL has reduced the shipping packaging to a minimum.
Packaging materials are always selected with regard to their possible recycling
ability.
12 Disposal
EN - 25