Changeable Body - Abicor Binzel ROBO WH Serie Instructivo De Servicio

WH and WHPP
9.4 Torch neck

9.5 Changeable body

10 Troubleshooting
In order to increase the system availability of the welding robot,
ABICOR BINZEL offers the option of automated torch cleaning.
1 Remove gas nozzle.
2 Remove welding spatter and spray gas nozzle with the ABICOR BINZEL
anti-spatter agent.
3 Check wearing parts for visible damage and replace them, if required.
4 Replace equipment kit when worn or soiled.
5 Clean separating point and O-rings with silicone-free sealing grease.
6 Check TCP after each use or after a collision in the WH setup device.
WH/WHPP
1 Clean coupling parts and slightly grease them with silicone-free sealing
grease.
2 Check clamp clip for visible damage and replace the complete changeable
body, if required.
WHPP
3 Replace pressure lever, guide and wire delivery nipple when worn out.
NOTE
• When replacing the wire type or the wire diameter, the wire feed roller
must also be replaced.
• Maintain the contact area between the torch neck and the changeable
body flat and free of soiling.
• When mounting the insulating shells, make sure that no control lines are
squeezed.
NOTE
• Some problems are listed below, with descriptions of possible causes
and solutions. If the measures described below are not successful, please
consult your dealer or the manufacturer.
• Please also consult the operating instructions for the welding
components, such as power supply, air pressure line.
10 Troubleshooting
EN - 23