Responsibilities Of The User - Abicor Binzel ROBO WH Serie Instructivo De Servicio

WH and WHPP
1 Identification
1.1 CE marking

1.2 Responsibilities of the User

The Welding torch system WH/WHPP is used in industry and in the trade for
inert gas welding using inert gases (MIG) or active gases (MAG). It allows the
torch neck to be easily changed either manually or automatically. The
automatic change is done in connection with the ATS rotor. This series can be
used in all welding positions. Depending on the model, the welding torch is
either air- or liquid-cooled. The liquid-cooled model requires a re-circulating
cooling unit. These operating instructions only describe the Welding torch
system WH/WHPP. The welding torch system may only be operated with
original ABICOR BINZEL spare parts.
This device fulfils the requirements of the relevant EU directives.
Conformity is confirmed by the CE marking on the device.
Within the EEA (European Economic Area) the current version of the national
implementation of the Framework Directive (89/391/EEC) and the related
individual directives and, of these, especially Directive (89/655/EEC)
concerning the minimum safety and health requirements for the use of work
equipment by workers at work must be adhered to. In Germany, the Job
Protection Law and the Company Safety Ordinance must be heeded.
In addition, the operator must ensure that the welding torch and welding unit
comply with the EMC Directive (2014/30/EU) and that the signal utilization
of the integrated welding current monitoring against stray currents is installed
properly.
1 Identification
EN - 3