Tubular Flip Up Armrest - Ki Mobility Liberty FT Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
D. Tubular Flip Up Armrest
WARNING: Do not use tubular flip up armrests to support your weight for pressure relief or
during a transfer. The tubular flip up armrests are for resting your arms on only and using them to
support your weight could result in a fall and serious injury.
1. Flip Up
a. Lift armrest up until stop block (Fig. 3:A) rests against backrest cane.
2. Flip Down
a. Lower armrest down until top section of stop block (Fig. 3:A) rests against the backrest
cane.
Fig. 3
3. Height Adjustment
a. Remove screw (Fig. 4:C), washer (Fig. 4:B) and nut (Fig. 4:A) using a 5mm Allen wrench
and a 10mm wrench.
NOTE: The saddles in between the armrest and the backrest tube will drop once hardware is
removed. Save saddles for later use.
b. Move the armrest to the hole on the backrest tube that matches your armrest height pref-
erence.
c. Reinstall hardware from step A and repeat on opposite side, using same holes so armrests
are level.
A
Fig. 4
A
B
C
15
A