Adjusting/Installing Strap - Ki Mobility Liberty FT Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
M. Adjusting/Installing Strap
Strap Routing
1. Strap is attached to one bracket. Take the opposite end of the strap and go under, over and
under the middle clip. Take the end of the strap up through the end bracket and out. Route
the strap back to the middle clip and go under, over and under again. See Fig. 20 for help
with strap routing.
Fig. 20
Strap Adjustment
1. Remove all slack in strap by pulling the end of the strap. You may need to help push slack
through the middle clip and then pull the end of the strap to remove the slack in some cases.
2. Verify that chair folds and unfolds properly.
NOTE: All three cross struts should go over center during folding when adjustments are correct.
Fig. 21
Pull to
remove slack.
23