Automatic Circuit Breaker - Irritrol KwikDial Guia Del Usuario

Clock Time Format Option
Time of day can be displayed in either 12-hour AM/PM
or 24-hour format.
1. Turn control dial to the Special Functions
2. Press the button as needed to select the clock
time format option designated by 12H or 24H.
3. Press the or button to display the desired
format.
4. Turn control dial to the Auto
Program Erase
The Program Erase feature enables you to easily clear
the controller memory of all program start times, station
run time duration and water budget information for a
selected program or all programs without changing the
current time, date and language option.
1. Turn control dial to the Special Functions
2. Press the button as needed to display CLR.
3. Program A will be displayed. If needed, press the
button once to select program B. Press the button
again to select program C. Pressing the button again
selects programs A, B and C.
4. Press the to display the program letter(s) and OK?.
5. Press button to clear the program(s) (CLR will be
displayed) or press the
6. Repeat steps 3–5 to clear any remaining program(s)
as needed.
7. Turn control dial to the Auto
position.
position when finished.
position.
button to cancel.
position when finished.
Enable / Disable Expansion Port
Your KwikDial controller is capable of remote control
operation when used in conjunction with the KwikStart
remote system. The expansion port provided for the
remote receiver connection must be switched On to
enable KwikStart remote control operation.
1. Turn control dial to the Special Functions
2. Press the button as needed to select
the expansion port switch option designated by XP - -.
3. Press the or button to select Y (yes, expansion
port on), or - - (expansion port off).
4. Turn control dial to the Auto

Automatic Circuit Breaker

The KwikDial controller features an electronic circuit
breaker which automatically detects an overload
condition on a station terminal during operation and turns
off the station before controller damage can occur. The
KwikDial advances to the next programmed station in
sequence to continue the watering cycle.
After the program watering cycle has finished, FUSE and
the number of the skipped station(s) will be displayed
in alternating sequence with the current time of day.
When all station numbers and FUSE are displayed, the
master valve is malfunctioning. Pressing the
will remove the warning display.
Important: The most common cause of an overload
condition is a short circuit in the valve wiring or a
malfunctioning valve solenoid. The cause of the overload
condition should be corrected before continuing to operate
the controller.
position.
position when finished.
button
17