Digital Outputs - Lenze L-force Drives 9400 E94BSHE Serie Manual De Instrucciones

6 Wiring the device
Control terminals
Analog inputs, analog outputs
Terminal X3
SSP94000X3
Terminal data
Flexible
With wire end
ferrule
)
Note!
If the control terminals are completely wired, we recommend to use a cable
cross−section of max. 0.75 mm
be attached.

Digital outputs

Terminal X4
9400SSP000X4
Terminal data
Flexible
With wire end
ferrule
126
Labelling Description
GA GND analog signals
AO1 Analog output 1
AO2 Analog output 2
A1+ Analog input 1 +
A1− Analog input 1 −
A1− Analog input 1 −
A1R Terminating resistor for ±20mA
A2+ Analog input 2 +
A2− Analog input 2 −
"
Shield connection: Fix the shield with EMC wire clamp.
Conductor cross−section
2
[mm ]
0.2 ... 2.5
2
Labelling Description
GO GND digital out
24O 24−V digital out
DO1 Digital output 1
DO2 Digital output 2
DO3 Digital output 3
DO4 Digital output 4
Conductor cross−section
2
[mm ]
0.2 ... 2.5
l
Tightening torque
[AWG] [Nm]
24 ... 12
to save space. The mechanical cover can then
Tightening torque
[AWG] [Nm]
24 ... 12
[lb−in]
Spring terminal
[lb−in]
Spring terminal
EDK94SH366 DE/EN/FR/ES/IT 7.0