To Clean The Cold Air Intake Of The Engine; To Clean The Hydraulic Oil Cooler; To Remove The Covers; To Remove The Engine Cover - Husqvarna P 524 Manual De Usuario

To clean the cold air intake of the
engine
WARNING: Stop the engine. The cold air
intake rotates and can cause injury to your
fingers.
1. Make sure that the air intake grille is not blocked.
Remove grass and dirt with a brush.
2. Remove the engine cover.
3. Make sure that the cold air intake is not blocked.
Remove grass and dirt with a brush.
4. Examine the air duct on the inner surface of the
engine cover. Make sure that the air duct is clean
and does not rub against the cold air intake.
24

To clean the hydraulic oil cooler

Make sure that the fan for the hydraulic oil cooler is not
blocked and that the area around the hydraulic oil cooler
is clean. Remove grass and dirt with a brush.

To remove the covers

To remove the engine cover

1. Move the seat fully forward. See
on page 16 .
2. Tilt the seat forward.
3. Remove the cotter pins and clevis pins from the
hinges behind the seat.
4. Pull the clips on the engine cover rearward. The clips
are found on the inner surface of the engine frame.
5. Lift and remove the engine cover.

To remove the front cover

1. Release the clip on the front cover with the tool
attached to the ignition key.
To adjust the seat
242 - 003 -