Iso Ddin Radio Provision - Metra 99-5816 Instrucciones De Instalación

ISO DDIN radio provision

1. Carefully using a utility knife, cut the
center bar out of the radio housing
trim panel. (Figure A)
2. Snap the ISO DDIN brackets to the
inside edge of the radio housing
trim panel. (Figure B)
3. Slide the radio into the bracket/radio
housing trim panel assembly and
secure the radio to the assembly
using the screws supplied with the
radio. (Figure B)
4. Snap the ISO DDIN trim plate onto
the front of the radio housing trim
panel. (Figure C)
5. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the radio for proper operation.
6. Reassemble the dash in reverse
order of disassembly.
Kit Assembly
(Figure A)
(Figure B)
99-5816
(Figure C)
7