Kit Assembly; Din Radio Provision With Driver Information Center (Dic); Iso Din Radio Provision With Driver Information Center (Dic) - Metra 99-3303 Instrucciones De Instalación

DIN radio provision with driver
information center (DIC)
1. Remove the metal DIN sleeve from
the aftermarket radio.
2. Slide the sleeve in the radio
housing and secure by bending the
metal locking tabs down.
Note: A DIN spacer has been
provided for applications where
depth is an issue. If using the spacer,
attach it to the sleeve before sliding
it into the radio housing. (Figure A)
3. Slide the radio back into the sleeve
until it clicks in. (Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test the
radio for proper operation.)
5. Reassemble the dash in reverse
order of disassembly.
Continue to final assembly

Kit Assembly

(Figure A)
(Figure B)
99-3303
ISO DIN radio provision with driver
information center (DIC)
1. Remove the metal DIN sleeve and
trim ring from the aftermarket
radio.
2. Secure the ISO brackets to the
radio using the screws supplied
with the radio. (Figure A)
3. Slide the radio into the radio
housing until it snaps into place.
(Figure B)
4. Snap the ISO trim plate onto the
front of the radio housing. (Figure B)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test the
radio for proper operation.)
5. Reassemble the dash in reverse
order of disassembly.
Continue to final assembly
6
(Figure A)
Right Side Clip
(Figure B)