Kit Assembly - Iso Ddin Radio Provision - Metra 95-5812 Instrucciones De Instalación

1. For the Ford Freestar 2004-2007, Mercury Monterey
2004-2007, Ford Focus 2005-2007 and the Ford F Series
Super Duty 2005-up: Do not cut the rear mounting tabs
from the double DIN brackets. If your vehicle is not listed
above move to step 2.
2. If your vehicle was not listed above, attach the included spacers
to the back of the radio housing mounting tabs. (Figure A)
Note: Use the screws supplied with this kit to mount the radio
housing in the vehicles that require the spacers. Not all vehicles
will require spacers.
3. Cut and remove the rear mounting tabs on the double DIN
bracket. (Figure B)
4. Attach the double DIN brackets to the radio housing. (Figure C)
Note: The notch in the housing should be on top.
5. Slide the double DIN radio into the radio housing/bracket
assembly and secure the radio to the assembly using the
screws supplied with the radio. (Figure D)
6. Locate the factory wiring harness in the dash. Metra
recommends using the proper mating adapter from Metra or
AXXESS. Re-connect the negative battery terminal and test the
unit for proper operation.
7. Reassemble dash in reverse order of disassembly.
Kit Assembly 95-5812
ISO DDIN radio provision
(Figure A)
(Figure C)
10
(Figure B)
(Figure D)