Replace The Hydraulic Oil; Lubrication, General Information; To Clean The Product - Husqvarna P 535HX Manual De Usuario

Symbols on the quick maintenance
guide
Replace the filter
Replace the oil
Examine visually or do a check of the oil
level
Lubricate the grease nipple with grease
Lubricate with engine oil
Do a check of the condition and tension of
the drive belt
Replace the drive belt
Replace the blades

Lubrication, general information

• Remove the power key to prevent accidental
movements during lubrication.
• Use engine oil when you lubricate with an oil can.
• When you lubricate with grease, use a chassis or
ball bearing grease that prevents corrosion. Remove
unwanted grease after lubrication.
• Lubricate 2 times a week if you operate the product
daily.
• Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean with
alcohol. If the friction between the drive belt and the
pulley is not sufficient after you clean with alcohol,
replace the drive belt.
CAUTION:
petroleum products to clean drive belts.
1591 - 001 - 21.12.2020
Do not use gasoline or other

To clean the product

WARNING:
STOP position and turn the main switch to
OFF before you clean the product.
CAUTION:
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause damage to the product.
Clean the product after use. Let the product cool down
before you clean it.
• Before you clean the product with a wet cloth, clean
the product with a soft brush or compressed air.
Remove grass cuttings and dirt on and around the
transmission.
• Use a wet cloth to clean the product. Clean plastic
parts with a clean and dry cloth.
• Do not use water or detergents near electrical
components or bearings. Liquids can cause damage
to the electrical components and bearings.
• To clean the cutting deck, put the cutting deck in
service position, if possible, and hose it down with
water.
• When the product is clean, start the cutting deck for
a short period to remove the remaining water.
To clean the cold air intakes
CAUTION:
daily or more frequently if necessary. A
blocked cold air intake can make the product
become too hot.
To clean the cold air intake of the battery
cooling system
• Make sure that the cold air intake grille is not
blocked. Remove grass and dirt with a soft brush.
Turn the power key to the
Do not use a high-pressure
Clean the cold air intakes
43