Lubrication Overview; Lubrication, General Information; To Lubricate Cables - Husqvarna P 524 Manual De Usuario

Lubrication overview

6
4
1. Rear axle bearing
2. Link rod
3. Articulation bearing
4. Front axle bearing
5. Steering cylinder
6. Lift chain axle

Lubrication, general information

• Remove the ignition key to prevent accidental
movements during lubrication.
• Use engine oil when you lubricate with an oil can.
• When you lubricate with grease, use a chassis or
ball bearing grease that prevents corrosion. Remove
unwanted grease after lubrication.
• Lubricate 2 times a week if you operate the product
daily.
242 - 003 -
3
1
4
1
5
• Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean with
alcohol. If the friction between the drive belt and the
pulley is not sufficient after you clean with alcohol,
replace the drive belt.
CAUTION: Do not use gasoline or other
petroleum products to clean drive belts.

To lubricate cables

• Lubricate the 2 ends of the cables and move the
controls to the end positions.
• Attach the rubber covers on the cables after
lubrication.
1
2
37