Warnings And Notes - Jacuzzi START! 70 Manual De Instalación, Uso Y Mantenimiento

Warnings and notes

• Make sure that installation is performed by qualified
personnel.
• It is dangerous to use or access the components of the
electrical system while the shower panel is in use.
• After using any "water jet" function, turn off the stop tap. It is
advisable to turn the diverter to the "showerhead" position.
• If the Start! shower panel is supplied with hot water from an e-
conomic-type gas boiler with mechanical flame modulation, the
boiler may not be able to supply water continuously at the re-
quired temperature, so there may be some variations in the wa-
ter temperature. In this case, if it is not possible to replace the
boiler with an electronic-modulation one, it is advisable to get
a qualified technician to lock the flame modulation of the boil-
er and only use the shower panel mixer tap to regulate water tem-
perature.
• The water supply (hot/cold water) must ensure well-bal-
anced pressures. A considerable difference in pressure may
prevent correct and speedy adjustment of the water tem-
perature.
For all maintenance and/or repair operations that require
the replacement of components, original Jacuzzi
parts must be used, since failure to comply with this reg-
ulation will relieve the manufacturer of any liability for
damage.
In case of difficulty...
PROBLEM / solution
WATER IS NOT SUPPLIED FROM VARIOUS FUNC-
TIONS (SHOWERHEAD, LARGE SHOWER HEAD,
ETC.).
• Turn on the mixer tap.
THE SHOWERHEAD PROVIDES INADEQUATE PRES-
SURE
• Clean the filter situated between the flexible hose and the
shower head.
LITTLE WATER IS SUPPLIED FROM ALL FUNCTIONS
• Check that the plumbing system meets the pres-
sure/capacity specifications on the technical pre-installa-
tion data sheet.
• Check that the thermostatic valve filter is not blocked with
dirt and/or lime scale.
THE HYDROMASSAGE PROVIDES INADEQUATE PRES-
SURE
• Clean the nozzles. If this does not work, contact the
Jacuzzi ® Service Centre to check the pressure and the wa-
ter system capacity.
DIFFICULT TO ADJUST THE WATER TEMPERATURE
(MIXING)
• Check that the pressure values of the system (operating)
for hot and cold water are well-balanced. If the values are
different, it is advisable to contact your plumber.
® spare
18