Service And Repair; Clearance Requirements - RIDGID MegaPress Manual Del Operador

Service and Repair

WARNING
Improper service or repair can make attachments
unsafe to operate.
The "Maintenance Instructions" will take care of most of
the service needs of this machine. Any problems not ad -
dressed by this section should only be handled by an
authorized RIDGID service technician.
No Service parts are sold for these attachments. If parts
are needed, the attachment should be discarded and a
new unit purchased.
For information on your nearest RIDGID Independent
Service Center or any service or repair questions:
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or www.RIDGID.eu to find
your local RIDGID contact point.
• Contact RIDGID Technical Services Department at
rtctechservices@emerson.com or in the U.S. and
Canada call (800) 519-3456
Disposal
Parts of the equipment contain valuable materials and can
be recycled. There are companies that specialize in recy-
cling that may be found locally. Dispose of the compo-
nents in compliance with all applicable regulations. Contact
your local waste management authority for more infor-
mation.
MegaPress ® Fitting System

Clearance Requirements

The following figures illustrate the clearance require-
ments for the jaws and fittings and the procedure for
pressing fittings in tight quarters with rings.
Clearance Requirements – Standard Series
MegaPress Jaw Sets
B
A
A (min.)
Pipe Dia.
Inches
1 / " 1"
2
3 / " 1 1 / "
4 4
1" 1 3 / "
4
C
B
A
A (min.)
Pipe Dia.
Inches mm
1 / " 1 1 / " 32
2 4
3 / " 1 1 / " 38
4 2
1" 2" 51
B (min.)
mm Inches mm
26 2 5 / " 67
8
32 3 1 / " 79
8
45 3 5 / " 92
8
B (min.) C (min.)
Inches mm Inches mm
1 7 / " 48 3 76
8
2 1 / " 54 3 1 / " 89
8 2
2 1 / " 64 4" 101
2
11