Programming Aurelia V - Nuova Simonelli Aurelia II Serie Instrucciones De Manejo

ON OFF STAND-BY
(ENERGY SAVING MODE)
This allows to rotate into the three working
modes/statuses.
Press RESET for 3 sec to switch on
off stand-by the machine status.
7.4 PROGRAMMING
AURELIA V
DOSE PROGRAMMING
To access the programming units, proceed as
follows:
NOTE: the procedure can be carried out with
the machine on.
To access the dose programming state of
each unit press the first unit's continuous
delivery key for 5 seconds.
The delivery keys will begin to flash on and
off.
Access into the first unit's programming
allows you to set the machine's function
parameters.
COFFEE DOSE PROGRAMMING
To program the relative water doses for one of
the delivery keys, proceed as follows:
fill the filter-holder with the correct dose of
coffee (the filter-holder can be single or dou-
ble depending on the key you wish to pro-
gram).
Insert the filter-holder into the unit.
Press one of the delivery buttons (see illus-
tration):
70
The delivery will start; once the desired
amount has been reached, press the con-
tinuous keys.
The delivery will stop and the chosen dose
key will turn off (the other keys will continue
to flash).
Press the continuous
gramming or to continue programming other
dose keys.
NOTE: This procedure can be used on all units
on the machine, as long as one unit is
selected at a time, the others can con-
tinue to operate normally, except when
the first unit is being programmed.
HOT WATER PROGRAMMING
Enter the programming mode using the rel-
st
evant procedure for the 1 unit on the right.
Press the hot water selection key
Hot water delivery will start.
Set the dose of hot water required and then
hot water key again.
press the
Press the continuous
programming or to continue programming
other selection keys.
Technician: To enable the pump while hot water
is being dispensed, enter the pro-
gramming mode for the first dispens-
ing group then press the continual
button for the second group.
To change the settings, it is sufficient to
press the hot water button
ton is not lit, the pump will not be enabled
while hot water is being dispensed; if the
button is lit while hot water is dispensed, the
pump will be activated.
key to exit pro-
Press the continual button
ond dispensing group to confirm the setting.
PROGRAMMING TIMED STEAM / LIQUID
TEMPERATURE
Enter the programming mode using the rel-
evant procedure for the 1
Press the steam selection key
Steam ejection will start.
Set the amount of steam required and press
the
Press the continuous
.
programming or to continue programming
other selection keys.
If the probe is fitted, the temperature at the
end of delivery will be stored to memory.
key to exit the
AUTOMATIC CUP-WARMER PROGRAMMING
(if present on the machine)
Enter the programming mode using the rele-
vant procedure for the 1
Press the cup-warming selection key
The delivery keys of the first and second unit
will respectively signal the allotted automatic
switching on and off times while the continu-
ous
will flash on and off.
As described in the chart, each delivery key
; if the but-
for the sec-
st
unit on the left.
.
steam selection key again.
key to exit the
st
unit on the left.
keys of the first and second units
.