Changing Overlay Film - ATON DHTP1 Manual Del Usario

DHTP1 Amplifi ed Touch Pad Controller
Screw
Screw
Figure 2.2: Installing the DHTP1

Changing Overlay Film

The DHTP1 features available customized Graphic
Overlay Films that can be changed to fi t the décor of
the room in which the touch pad is installed.
To change fi lms:
1. Remove the wall plate from the front
of the unit. Remove the two screws and wall
plate base.
2. Remove the two fi lm screws on the top frame
of the unit.
3. Use the notch located in the upper right-hand
corner to open the glass cover (45° max.).
4. Remove the existing fi lm.
5. Place the new fi lm into the holder of the transpar-
ent glass cover making sure of the proper
orientation.
© 2007 • All rights reserved.
Rough-In
Box
Screw
DHTP1
Screw
Cat-5
Stud
16AWG
2 Conductors
9