Display Timeout Length - ATON DHTP1 Manual Del Usario

DHTP1 Amplifi ed Touch Pad Controller
• Whole House Music
• Do Not Disturb

Display Timeout Length

This setting determines the amount of time that the
touch surface backlight and LED display area re-
mains ON after the last button press. Factory Default
is 30 seconds. See Figure 4.1.
To adjust the Display Timeout Length:
1. Press and hold the PROGRAM
pressing and holding the area indicated
Source 1 LED will blink rapidly.
2. Each Source Number
Timeout Length.
Source Number
1
2
3
4
L
3. Use the Source Left/Right Button
between the numbers 1-L for the desired Display
Timeout Length.
4. Once the Display Timeout Length has been set,
© 2007 • All rights reserved.
1
represents a Display
3
Display Timeout Length
30 Seconds (Factory Default)
1 Minutes
2 Minutes
3 Minutes
No Time Out
button while
. The
2
to Select
4
19