ATON DHTP1 Manual Del Usario página 19

DHTP1 Amplifi ed Touch Pad Controller
To make connections:
1. Strip the ends of the 16 AWG wire 1/4" on both
ends of the wire run.
2. Remove the terminal strip from the AUX POWER
OUT connector on the DH44/DH46X.
3. Loosen the screws for the appropriate zone's
terminal pairs on the terminal strip.
4. Insert the wires into the terminal strip, paying
close attention to polarity (+/-).
5. Tighten the screws on the terminal strip.
6. Loosen the screws on the DHTP1's AUX Power
Input terminal.
7. Insert the wires into the terminal, paying close
attention to polarity (+/-).
8. Tighten the screws on the DHTP1's AUX Power
Input terminal.
9. Replace the terminal strip on the AUX POWER
OUT connector on the DH44/DH46X.
© 2007 • All rights reserved. 13