Page/Doorbell Volume Level - ATON DHTP1 Manual Del Usario

DHTP1 Amplifi ed Touch Pad Controller

Page/Doorbell Volume Level

This setting determines the Page/Doorbell Volume
Level for the zone in which the DHTP1 is installed.
See Figure 4.2.
To adjust the Page/Doorbell Level:
1. Press and hold the PROGRAM button
then press "VOL ▼" at the area indicated
The Volume Bar
Page/DB volume level. At this point the DH44
will switch to the Page/DB audio input.
2. Activate the page or doorbell audio from the
connected communications controller.
3. Press VOL UP or DOWN
Doorbell Volume Level accordingly in each zone.
4. Once the Page/Doorbell level has been set,
press the PROGRAM Button again
will be saved and the Touch Pad will exit
Setup Mode.
© 2007 • All rights reserved.
3 will display the existing
4 to adjust the Page/
1
2
1 . Settings
21