Installation - ATON DHTP1 Manual Del Usario

Installation

The DHTP1 is designed to mount in a standard
single- gang rough-in box (J Box). Typical mounting
height is 56-60" from the fl oor to the bottom of the
frame. This provides optimum viewing for the largest
number of people.
Note: Do not mount the DHTP1 in the same
rough-in box as high voltage devices such as
electrical outlets or switches.
After running Cat-5 and terminating the ends, route
the wires from the DH44 or DH46X and DHSIP (if
applicable) into the back of the rough-in box, then
connect them to the appropriate RJ-45 connectors on
the rear of the DHTP1. Connect all 16 AWG 2 conduc-
tor speaker wires. If using an IR Receiver, strip the
ends of three conductors of the Cat-5 and insert into
the screw terminals of the IR Input Jack. Specifi c con-
nections are detailed in the Connections section.
Once connections are made, mount the DHTP1 in to
the rough-in box using the 2 provided screws. Mount
the Trim Plate Bracket as shown in Figure 2.2, then
snap the Screwless Trim Plate in place.
Make sure that the arrows on both the Trim
Plate Bracket and the Trim Plate are pointed UP.
8
DHTP1 Amplifi ed Touch Pad Controller
©2007 • All rights reserved.