In Case Of Difficulty - Alpine DVA-5200 Manual De Operación

In case of difficulty

• If operation freezes, the screen goes black or the unit should otherwise not function properly, try turning
the power off then back on. Alternatively, try the following methods in the order listed until the DVA-5200
returns to normal playbak mode:
1) Change the source from DVD to another source then return to DVD mode.
2) Turn the car's ignition OFF and back ON again.
3) Press the RESET button on the face of the DVA-5200.
• This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your
system is properly connected or consult your authorized Alpine dealer.
Symptom
Unit does not Fuse is blown.
operate.
Monitor's power is not turned on.
Condensation.
Operation is Remote control unit's batteries
unstable. are worn.
Remote control sensor or
transmitter is dirty.
No picture is Monitor's mode is not switched
produced. to the mode you want to see.
Monitor's parking brake cord is
not connected.
Monitor's parking brake is not
set.
Playback does not Disc is loaded upside-down.
start.
Disc is dirty.
A disc not able to playback with
this unit is loaded.
Parental lock is set.
Setup menu is displayed.
Picture is unclear Disc is being fast-forwarded or
or noisy. fast-reversed.
Vehicle's battery power is weak.
Monitor's fluorescent tube is
worn.
Image stops Disc is scratched.
sometimes.
NO DISC No disc is loaded.
Disc is dirty.
NOT VALID Remote control operation is not
possible.
REGIONAL CODE Disc does not match regional
VIOLATION code number.
VIDEO SIGNAL PAL disc is loaded.
SYSTEM IS NOT
CORRECT
PLEASE PUSH When Ai-NET address has been
RESET SW changed.
58
Cause
Replace with a fuse of the specified capacity. (See
installation instructions.)
Turn on the monitor's power.
Wait a while (about 1 hour) for the condensation to
dry.
Replace the remote control unit's batteries with new
ones.
Clean the sensor or transmitter.
Switch to the mode you want to see.
Connect the monitor's parking brake cord and set the
parking brake.
(For details, refer to the monitor's instructions.)
Check the disc and load it with the labeled side facing
upward.
Clean the disc.
Check if the disc is able to be played back
Cancel the parental lock or change the rating level.
Press "SET UP" to turn the menu off.
The picture may be slightly disturbed, but this is
normal.
Check the battery power and wiring.
(The unit may malfunction if the battery power is
under 11 volts with a load applied.)
Replace the monitor's fluorescent tube.
Replaced with a non-scratched disc.
Load a disc.
Clean the disc.
For some discs or playing modes, certain operations
are not possible. This is not a malfunction.
Load a disc that matches the regional code number.
Load an NTSC disc.
Press the reset switch on the connected Ai-NET head
unit, or turn the ignition switch off then back on.
Remedy