Turning The Power On And Off - Alpine DVA-5200 Manual De Operación

Turning the power on and off

POWER
• Reading this manual
Tips
8
Playing discs
Stopping playback
Stopping playback
Press the stop button during playback to
stop playback . That position is stored in
the memory.
Press " L " during playback.
• Using the PRE-STOP function
When the PRE-STOP function is
Tips
used, the position at which playback is
stopped is stored in the memory, and
playback resumes from that position.
Press " L L L L L " once during
playback.
"PRE-STOP" is displayed.
Press " : : : : : " in the PRE-STOP
mode.
Playback starts from the position at
which it was stopped.
Turning the power on
and off
Press "POWER".
The power turns on.
When connected with an Alpine
Caution
head unit
If the DVA-5200 is connected to
anything other than the CVA-1005,
the default DVD setting must be
changed. See page 35, "Custom
setting – Changing the Ai-NET
settings" to change the SETUP to
CD mode before using it.
To turn the power off, press
"POWER" again.
Notes:
• With this unit connected to an Ai-NET compatible
head unit, there will be about a 3 second delay
during power-up from the remote control. This is
caused by the systems communications being
carried out by the various components and is not
a defect.
• When connected with an Ai-NET compatible head
unit, the power cannot be turned off from the
remote control unit. Turn off the DVA-5200's
power by switching the head unit's source. For
details, refer to "Operating from the head unit"
(page 52).
These indicate the discs for which
the function can be used.
DVD
Video CD
CD
DVD
Video CD
CD
This indicates supplementary
explanation of operation of this
system.
POWER
...DVDs
...Video CDs
...Music CDs