Agilent Technologies TwisTorr 84 FS AG Serie Manual De Instrucciones página 152

Technical Information
Controller Installation
1
Turn the pump upside-down;
2
Place the square plate bracket on the pump bottom;
3
Place the eight screws in the holes on the pump bottom;
4
Tighten the screws properly;
5
Turn the pump again;
6
Place the pump aligning the 4 holes of the square plate in the holes on the top of
the controller;
7
Place the four screws on the top of the controller;
8
Tighten the screws properly;
9
Plug the line cord and connect the pump cable to the pump;
10 Connect the mating connector with the jumper on the interlock signal to start the
pump.
152/192 TwisTorr 84 FS AG Navigator Controller User Manual / 87-901-038-01 (A)