Preparing For Installation - Bartscher C4431D Manual De Instrucciones

•
Never place the device near flammable materials or containers, or install with
flammable materials (such as walls, furniture, partition walls, gas cylinders), this
can cause a fire. In the event that such an installation is not possible, cover the
combustible parts with non-flammable heat-insulating material under the maximum
compliance with the fire safety regulations.
•
Do not place any objects on the device.

5.1.3 Preparing for Installation

•
Remove the external packaging (wooden box and / or carton) and dispose them in
accordance with the applicable provisions of the installation country.
Removal of the protective foil
•
Completely remove the protective foil from the
external and internal walls.
•
Remove from the internal accessories, all
information materials and plastic bags.
CAUTION!
Never remove the nameplate and
warning notes from the device.
Adjustment of the feet
CAUTION!
Do not use the device without adjustable feet!
•
If the device is operated without adjustable feet, no air passage for cooling the
electronic components and the external walls of the housing is ensured, this could
cause overheating and result in damage of the components of this device.
•
The adjustable feet are enclosed to the device and must be screwed under the
device. The correct flatness of the device ensures a smooth operation. This flatness
is obtained by adjusting the feet and verification by a spirit level. It is sufficient, to
screw them in or screw out to change their settings.
- 46 -