Disassembly - MSA Workman 30 Manual De Servicio Y Reparacion

Disassembly

5 Disassembly
US
16
(1) Use a screwdriver and remove the 8 tamper-proof M4
screws and 2 tamper-proof M3 screws from the
housing.
(2) Remove the back housing.
(3) Remove 2 screws from the inside of the front housing
that connect the frame to the housing.
(4) Remove front housing.
NOTE: To safely unwind the power spring, remove the
pawl side frame first.
(5) Remove the M4 screws from the handle and screws
from the nozzle.
(6) Remove the snap ring from the center of the frame
and pull off the frame.
(7) Turn over the assembly and place the assembly and
place the cam into the power spring winding fixture.
(8) Hold frame with one hand and remove 2 screws from
the nozzle.
(9) Slowly unwind power spring counter-clockwise
7 to 8 turns (for 30ft/9m) or 9 to 10 turns
(for 50ft/15m).
Workman® 30' & 50'