Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7. INSTRUMENT CONNECTION TO A PC
The connection between PC and instrument is created using the serial port and optical
serial cable, provided with the software package.
Before making the connection it is necessary to select the COM port used for the
transmission. To set this parameter start the software and look up the help on line.
ATTENTION: The selected port shall NOT be shared by other devices or applications
(example mouse, modem, etc.)..
To transfer the stored data from the instrument to the PC keep to the following procedure:
1. Turn the switch on position RS232.
2. By means of the FUNC key select the mode "SEr":
FUNC
Then proceed according to the software instruction manual to transfer the
measurements performed.
Note: The download speed is: 9600 baud (see software instruction manual).
The
communication
instrument and PC occurs.
between
SE
Publicidad
Capítulos
Tabla de contenido
