Anomalous Cases During "Auto", "R+Timer", "R-Timer" Tests - Amprobe MultiTest 1000 Manual Del Usuario

4.1.3. Anomalous cases during "AUTO", "R+TIMER", "R-TIMER" tests

In case a value of Ravg or R+ or R-
greater than or equal to 5Ω but less
than 99.9Ω was detected, at the end of
the test the instrument emits a long
beep and displays a screen similar to
the screen alongside.
ATTENTION: value of R
In AUTO mode, if a Ravg or R+ or R-
greater than 99.9Ω was detected, at
the end of the test the instrument emits
a long beep and displays the screen
alongside.
ATTENTION: value of R
high.
In the case mode R+TIMER or R-
TIMER was selected and a R+ or R-
greater than 99.9Ω was detected, the
instrument emits an intermittent beep
during the test, a long beep at the
end of the test and displays the screen
alongside.
In case that:
R -R
MEASURED CALIBRATION
instrument
alongside.
ATTENTION: R
SAVE
SAVING:
greater than 5Ω
avg
or R+ or R- is too
avg
< 0Ω
displays the
-R < 0
MEASURED CALIBRATION
The tests can be stored pressing the SAVE key twice (refer
to paragraph 5.1).
CAL LOW
5.75
216
5
AUTO
CAL LOW
> 99.9
- - -
AUTO
CAL LOW
> 99.9
- - -
TIMER
CAL LOW
the
ν 0.00
screen
219
AUTO
Ω
Ω
mA
s
Ω
Ω
mA
Ω
Ω
4
mA s
R+
Ω
Ω
mA
Only in the case
R+TIMER or R-
TIMER was
selected.
AUTO mode.
99.9Ω is the
maximum value
that can be
measured in the
LOWΩ AUTO or
R+ or R-mode.
AUTO mode.
99.9Ω is the
maximum value.
ATTENTION:
value of R+ or R-
is too high.
Blinking CAL.
AUTO mode.