Making The Pc Image Brighter (Abl) - Pioneer PDP-502MXE Manual De Instrucciones

Display Panel Adjustments
Making the PC image brighter
(ABL)
Set this mode to "ON" to brighten the image during PC
signal input. When ABL is set to "ON", the brightness of
the image will change according to changes in the input
signal. If you are bothered by changes to brightness
during operation, set this mode to "OFF".
1
Press MENU to display the menu screen.
The menu screen appears.
2 Press 5/∞ to select SET UP, then press SET.
M A I N M E N U
P I C T U R E
S C R E E N
A L L R E S E T
P OW E R S A V E
S E T U P
M E N U : M E N U
O F F
: S E L E C T
3 Press 5/∞ to select ABL.
S E T U P
T E R M I N A L : B N C
S E T T I N G : P C
S I G N A L : R
C L A M P : M O D E 1
A B L O F
:
:
H . E N H A N C E
:
V . E N H A N C E
E X I T
: S E L E C T S E T : C H
20
En
S E T : N E
X T
G B
F
0
0
A N G E
4
Press SET to set the mode to "ON".
"ON" is set when this unit is shipped from the
factory.
S E T U P
T E R M I N A L : B N C
S E T T I N G
: P C
S I G N A L
: R G B
C L A M P : M O D E 1
A B L O N
:
:
H . E N H A N C E
:
V . E N H A N C E
E X I T
: S E L E C T S E T : C H
Each time SET is pressed, the settings change in the
following order.
3 ON
OFF 2
5
When the setup is finished, press MENU to exit
the menu screen.
Note
Make the setting for each input (INPUT3 or INPUT4).
0
0
A N G E