Sanus VMPL3 Manual De Instrucciones página 7

2
Mount the Wall Plate
Solid concrete or concrete block
2-1 Mark the wall
406 mm
(16 in.)
2-2 Drill pilot holes
2-3 Insert anchors and lag bolts
[12]
[10]
6901-002348 00
406 mm
(16 in.)
75 mm
(3 in.)
Insert lag bolt anchors [12]. Then insert lag bolts [10] through the washer [11], wall plate
[01] and into the anchors [12].
CAUTION:
potential injuries or property damage:

Be sure the anchors [12] are seated fl ush with the concrete surface.

Tighten the lag bolts [10] only until the washers [11] are pulled fi rmly against the
wall plate [01].

DO NOT over-tighten the lag bolts [10].
[11]
For assistance in determining wall plate location, see Height
Finder at sanus.com.
Level the wall plate [01] and mark the hole locations.
CAUTION:

Mount the wall plate [01] directly onto the concrete surface.
[01]

Minimum solid concrete thickness: 203 mm (8 in.).

Minimum concrete block size: 203 x 203 x 406 mm (8 x 8 x
16 in.).

If wall plate [01] is extended, ensure at least two lag bolts
[10] washers [11] and anchors [12] are fastened to each of
the three plates. All six fasteners must be used.

Minimum horizontal space between fasteners: 406 mm (16
in.).
CAUTION:

Pilot holes MUST be drilled to a depth of 75 mm (3 in.) using
a 10 mm (3/8 in.) diameter drill bit.

Never drill into the mortar between blocks.
Improper use could reduce the holding power of the lag bolt. To avoid
[10]
[11]
13 mm
(1/2 in.)
Avoid potential injuries or property damage!
Avoid potential injuries or property damage!
[01]
10 mm
(3/8 in.)
7