Inflation; Inflation Of Tires With Tube - Beissbarth MS 63 Manual Original

3. Lay the tire bead on the lower left edge of the
mounting tool tab.
4. While holding the bead in the semi-drop centre press
the rotation pedal and keep turning the locking plate
until the upper tire bead has passed close to the
mounting tool (1) and it has gone under the edge of
the rim.
1
i
Be sure that the bead is inserted in the drop centre
of the rim in order to eliminate bead yields; in order
to make his operation easier, it is suggested, during
rotation of the locking plate, to assist with a bit of
pressure the insertion of the bead in the rim.
i
In case of tires with tube, press the tilting column
pedal to tilt the column backwards; place the rim so
that the valve hole of the tube is positioned at about
90° degrees relatively to the mounting tool position
and, if needed, the tube.
5. Repeat the same operations for the insertion of the
second bead.
i
In case of RFT or UPH tires, in order to hold the bead
inside the semi drop centre, the use of accessories
like clamps, wedges or of the TECNOROLLER SL
bead breaker is suggested.
6. Press the tilting column pedal to tilt the column
backwards.
7. Press the locking jaw pedal to release the rim.
Beissbarth GmbH
Operating instructions | MS 63 | 33
5.3

Inflation

Inflation can generate potential danger
situations. The operator has to carry out the
necessary precautions in order to guarantee
operational safety.
!
Safety device:
To protect the operator from eventual dangers that
can occur during tire inflating on the locking plate,
the MS 63 has been equipped with a valve that limits
operational pressure to 3,5 bar and of a further val-
ve limiting maximum pressure to 3,8 bar!
5.3.1

Inflation of tires with tube

1. Screw the valve element.
2. Connect the inflation gun to the tire valve.
3. Inflate the tire, by operating on the inflation gun until
reaching nominal pressure.
en
|
1 695 106 288 2013-10-30