Swing-N-Slide Alpine PROJECT 611 Manual De Instrucciones página 139

Ocultar thumbs Ver también para Alpine PROJECT 611:
Tabla de contenido

Publicidad

LA 6683 Alpine 615_- 3/7/12 9:42 AM Page 3
This product is intended for single family home/residential use only and not intended for use in any public setting.
According to ASTM requirements, all kits must be anchored to the ground and, if the unit has a climbing rope, the rope end must be anchored to the ground. If soil conditions
permit stakes to be pulled out easily, cementing into ground is necessary.
• To anchor the unit to the ground, Follow the instructions included in this plan for applying Anchor-It devices to your unit, or use 2" x 4" x 18" (45mm x 95mm x 457mm) pressure-
treated stakes. Pound stakes into ground at least 12" (305mm) at all inside corners of the posts (including A-frame legs and climbing unit posts). Attach with four (4) 16D (3-1/2")
galvanized nails per stake into each tower and/or A-frame upright.
• If the unit has a climbing rope, anchor the rope end.
• Once the unit is completely assembled and before children are allowed to play on it, proper shock-absorbing surfacing material must be installed. This may be accomplished by
using loose-fill materials at a sufficient depth. The Consumer Product Safety Commission "Handbook for Public Playground Safety" lists the following materials and required
depths that are sufficient for home/residential application. For fall height protection up to 9 ft. (2.742m) [recommended for Swing•N•Slide kits]:
These depths were derived from the CPSC Handbook. Swing•N•Slide has not done independent tests to determine these required depths.
When properly installed, shock absorbing material will completely cover the horizontal baseboards on climbing units. This protective surfacing must extend a minimum of 6 ft.
(1.828m) in all directions from the perimeter of the equipment or from the outermost edges of any component. For example, a slide extending beyond the platform must have
protective surfacing at least 6 ft. (1.828mm) out from both sides as well as the end. For swings, the protective surface must extend at least 14 ft. (6m) out from both the back and
front of the swing when the swing is in its rest position.
For further information on playground safety,
(CPSC) publishes the Outdoor Home Playground Safety Handbook which can be downloaded for free
from www.cpsc.gov. An additional resource is the American Society of Testing and Materials (ASTM)
Standard Consumer Safety Performance Specification for Home Playground Equipment (ASTM F1148)
Swing-N-Slide® takes great pride in the quality and durability of our products. Our Manufacturer's Limited Warranty provides confidence and demonstrates our commitment
to providing quality residential playground products.
M NUF CTURER'S LIFETIME LIMITED W RR NTY
Swing-N-Slide® warrants its thermoformed slides and climbing mountains to be free from defects in workmanship and materials, under normal use and conditions, for the
lifetime of the product.
M NUF CTURER'S 5 YE R LIMITED W RR NTY
Swing-N-Slide® warrants its Custom Ready-to-Build Play Set kits and accessories to be free from defects in workmanship and materials, under normal use and conditions,
for a period of 5 years.
M NUF CTURER'S 5 YE R LIMITED W RR NTY
Swing-N-Slide® warrants its No-Cut and Wood Complete Ready-to- ssemble Play Set kits against wood rot and termite damage, and to be free from defects in
workmanship and materials, under normal use and conditions, for a period of 5 years for structural wood components.
Cosmetic defects that do not affect the structural integrity of the product, or natural defects of wood such as warping, splitting, checking, twisting, shrinkage, swelling or
any other physical properties of wood that do not present a safety hazard, are not covered by this warranty.
M NUF CTURER'S ONE YE R W RR NTY
Swing-N-Slide® warrants its canopy roofs and/or tarps, and Timber GLOVE lumber wrap to be free from defects in workmanship and materials, under normal use and
conditions, for a period of one year.
Swing-N-Slide® will repair, or at its discretion, replace any part within the stated warranty period which is defective in workmanship or materials. This decision is subject
to verification of the defect upon delivery of the defective part to Swing-N-Slide® at 1212 Barberry Drive, Janesville, Wisconsin, 53545.
Slide® must have prior approved Return uthorization Number and proof of purchase, including the date of purchase. This warranty is valid only if the product is used for
the purpose for which it was designed and installed at a residential, single family dwelling. This warranty is void if the product is put to commercial or institutional use. This
warranty does not cover (a) products which have been damaged by acts of Nature, negligence, misuse, or accident, or which have been modified or repaired by
unauthorized persons; (b) the cost of labor; or the cost of shipping the product, any part, or any replacement product or part.
Swing-N-Slide® DISCL IMS LL OTHER REPRESENT TIONS ND W RR NTIES OF NY KIND, EXPRESS, IMPLIED, ST TUTORY OR OTHERWISE, INCLUDING THE
IMPLIED W RR NTIES OF MERCH NTIBILITY ND FITNESS FOR
CONSEQUENTI L D M GES. This warranty is non-transferable and does not extend to the owners of the product subsequent to the original purchaser. Some states do not
allow limitations on implied warranties or exclusion of incidental or consequential damages, so these restrictions may not be applicable to you. This warranty gives you
specific legal rights. You may also have other rights, which vary from state to state.
This warranty also does not apply to:
• Structures not erected, maintained or inspected in conformance with Swing-N-Slide® installation plans
• Structures that have had parts added or substituted not in conformance with Swing-N-Slide® installation plans
Parts that have been modified, altered or misused
Parts that have not been used as designed or intended
Damage due to acts of Nature, vandalism, abnormal use or abuse as determined by Swing-N-Slide®
lacement in any public setting constitutes a misuse of this product.
IMPORT NT!
DDITION L REQUIRED S FETY INST LL TION INSTRUCTIONS
LOOSE FILL M TERI L
Wood Mulch
Double Shredded Bark Mulch
Uniform Wood Chips
Fine Sand
Fine Gravel
which can be purchased and downloaded from www.astm.org.
Swing-N-Slide® M NUF CTURERS LIMITED W RR NTY
P RTICUL R PURPOSE. Swing-N-Slide® WILL NOT BE LI BLE FOR NY INCIDENT L OR
1
REQUIRED (UNCOMPRESSED) DEPTH
in. (mm)
9" (229mm)
9" (229mm)
12" (305mm)
12" (305mm)
12" (305mm)
the Consumer Product Safety Commission
3
ny part(s) returned to Swing-N-

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Alpine project 612

Tabla de contenido