Swing-N-Slide Alpine PROJECT 611 Manual De Instrucciones página 26

Fig. 23
T-nut
86-1/2''
to ground
Washer
2-1/2''
screws/nails
Hex Bolt
2-1/2'' or 10D
screw/nail
L. A-Frame Assembly cont.
1. Attach A-Frame beam to Swing Beam using (2) hex bolts and 4 screws/nails.
2. Tighten hex bolt to flush with top of T-nut. Repeat on other bracket.
Note: If using Laminated Swing Beam, make sure t-nut teeth do not fall between seams of 2'' x 6''s.
26