QSC CXD Serie Manual Del Usuario página 16

Preset izard
NOTE!: The power levels shown in this procedure are taken from the CXD4.3 unless indicated otherwise. CXD4.2 will show less power
and CXD4.5 will show greater power. For complete details refer to the
HOME > PRESETS > PRESET WIZARD > ENTER
Step 1 — Adjust Impedance and Power
OUTPUTS
Output:
Imped:
Power:
Remaining Power Available: 1875 W
Enter Load Profile (Impedance and Power)
EN
Possible Output Mode Combinations using the Preset Wizard
*
25%
* Precentages are used to represent the power for different amplifier models.
Step 2 — Select Output Channel for Speaker Assignment
OUTPUTS
Output:
Imped:
Power:
Spkr:
Step 3 — Select Speaker Type for Channel
OUTPUTS
Speaker:
Band:
Filter:
TD-000367-00-A
SPEAKERS SAVE
A B C
8.0 - - - -
625 - - - -
A B C D AB C
- - - - - - - - - - - - - - - - - -
25% 25% 25% 50% 25%
Modes: A B = Separate Channels / A+B = Bridge Mode / AB = Parallel Mode
SPEAKERS SAVE
A B C
8.0 8.0 8.0
625 625 625
- - - - - - - - - - - -
Assign Assign Assign
SPEAKERS SAVE
Output: A
WL2102 BiLFNS
2-Way LF
80 Hz
ASSIGN
"Specifications" on page 28.
Adjust Impedance based on
the total loudspeaker load
D
connected to the channel.
Default = 8
- -
Default = min. for amp
- -
Impedance and Power
are dynamically linked
for adjustments.
D AB CD A+B C
- - - - - - - - - - - - - - -
25% 50% 50% 50% 25%
— Figure 25 —
When you are finished setting
the Impedance and Power for
D
each output, continue to scroll
to access the SPEAKERS tab.
8.0
Loudspeaker assignment is optional,
625
you can assign a loudspeaker to one
or more channels, or none at all.
- - - -
Assign
Band and Filter
selections are based on
the Speaker you select.
You must select a
loudspeaker before
selecting Band and Filter.
To assign the speaker to the output channel, press
16
Scroll to select (Imped or Power)
Turn to adjust parameter
To confirm, press
Repeat for remaining
output channels
D A+B C+D ABC D
- - - - - - - - - - - - - - -
25% 50% 50% 75% 25%
Scroll to select Output channel
To Assign a loudspeaker, press
Continue to Step 3.
To edit Speaker, press
Scroll to select a Speaker model
To confirm, press
Scroll to select (Band, Filter)
Turn to adjust parameter
To confirm, press
Scroll to select ASSIGN
To edit, press
ENTER
ENTER
AB + CD ABCD
- - - - - -
100% 100%
ENTER
ENTER
ENTER
To edit, press
ENTER
ENTER
ENTER