Festo DMES Serie Instrucciones De Utilizacion página 29

DMES−...
Work loads with their own guide
Adjust the guides of the work load and the DGC−... so that they are exactly
S
parallel.
You will then avoid overloading the guide (wear).
With hard and stiff work loads (steel)
Please note
If the aluminium slide becomes bent against
a buckled work load, the service life of the
guide will be reduced.
S Make sure that the mounting surface of
the work load is not bent more than as
follows:
GF: b 0.03 mm
KF: b 0.01 mm
With mass geometries with projection in the
longitudinal direction of the slide
Make sure that the work load does not
S
strike against the motor.
If necessary, turn the motor unit
S
MTR−DCI−... in the coupling housing
(compare Fitting mechanical
components").
Festo DMES−... 0602a English
Fig. 19
Fig. 20
Fig. 21
b
29