Cleaning; Shutting Down And Parking The Appliance; Emptying The Dirty Water Tank; Emptying The Fresh Water Tank - Kärcher BR 40/25 C Ep Manual De Instrucciones

Reducing the speed: Turn the wheel in –
direction.
Increasing the speed: Turn the wheel in
+ direction.
Connecting to the mains power
supply
Insert the looped end of the extension
cable in the strain relief hook.
Plug in the mains plug.

Cleaning

Turn the running gear to the back with
your foot.
Turn the program selection switch to the
desired cleaning program.
Set the water quantity according to the
degree of dirt accumulation and the floor
covering.
Lower the vacuum bar.
Turn on the brushes by pulling the con-
trol handle.
Warning!
Risk of damage to the floor covering. Do not
operate the appliance on the spot.
Shutting down and parking the ap-
pliance
Turn the water quantity control button to
the closed position.
Drive the appliance forwards for another
1-2 m to draw off residual water.
Turn the program selection switch to
"OFF".
Raise the vacuum bar.
10
English
Turn the running gear to the front with
your foot.
Disconnect the mains plug.
Warning!
Risk of deformation of brushes – when park-
ing the appliance, relieve the pressure on
the brushes by turning the running gear to
the front
Emptying the Dirt Water Reservoir
Note
If the dirt water reservoir is full the float clos-
es the suction channel. The suction opera-
tion is interrupted. Empty the dirt water
reservoir.
Warning
Please observe the local provisions regard-
ing the wastewater treatment.
Take the dirt water discharge hose from
the support and lower above a suited col-
lection device.
Let off water by opening the dosage de-
vice at the discharge hose.
The rinse the dirt water reservoir with
clear water.

Emptying the fresh water tank

Release the coupling at the upper end of
the fill level display.
Lower the hose for the fill level display
into a suitable collector and drain off liq-
uid.
Engage the coupling on the appliance
again.