Driving To The Place Of Use; Cleaning Programs; Battery Control Display; Setting The Vacuum Bar - Kärcher Tornado BR 40/25 C Bp Manual De Instrucciones

Driving to the Place of Use

When the running gear is turned to the front
the appliance can be pushed to the place of
use without any contact of the brushes with
the floor.
Raise the vacuum bar.
Press the appliance to the bottom using
the push handle.
Turn the running gear to the front with
your foot.
Use the push handle to push the appli-
ance to the place of use.

Cleaning Programs

3
2
1
1 OFF Appliance is not operational.
2 Scrub cleaning Wet cleaning the floor
and vacuum up dirt water.
3 Wet scrubbing Wet cleaning the floor
and allow the detergent to react.
4 Vacuuming Vacuuming up the detergent
solution.
5 Polishing Polishing the floor without the
application of liquid.

Battery control display

The battery control display shows the charg-
ing status of the batteries when the charger
is unplugged:
40-100% lights green
20-40% lights yellow
0-20% slowly flashes red
empty lights red
4
5

Setting the Vacuum Bar

Oblique position
To improve the vacuuming result on tiled
floors the vacuum bar can be turned to an
oblique position of up to 5°.
Release the wing nuts.
Turn the vacuum bar.
Tighten the wing nuts.
Inclination
If the vacuum result is unsatisfactory the in-
clination of the straight vacuum bar can be
modified.
Release the wing nuts.
Tilt the vacuum bar.
Tighten the wing nuts.
11
English