Complete Cleaning - Kärcher BR 30/4 C Manual Original

Establish mains contact
Swivel bottom cable hook upward and
remove cable.
Check mains cable and plug for dam-
age or breakage. Get them replaced
only through customer service agent or
an electrician.
Insert the mains plug into the socket.
Cleaning
Danger
Risk of injury on account of electric shock
caused by a damaged mains cable. Do not
let the mains cable come in contact with the
rotating brushes.
Caution
Risk of damage to the floor covering. The
cleaning method for severe soiling must
only be used on floors suitable for this kind
of cleaning.
Risk of damage to the fresh water pump if it
runs dry because of empty fresh water res-
ervoir. Monitor the fill level indicator and
switch the water pump switch off if the fresh
water reservoir is empty.
Normal soiling
Move the suction bar lift pedal to posi-
tion „suction off" (Fig. 3 - position "1/
ON", see inside front cover).
Press the park position release and
swivel the handle toward the rear.
Set main switch for brush/vacuum oper-
ation to "1".
Activate the water pump switch.
Move the appliance over the surface to
be cleaned.
Severe soiling
Caution
Risk of damage to the floor covering. The clean-
ing method for severe soiling must only be used
on floors suitable for this kind of cleaning.
Move the vacuum bar lift pedal to position
„do not suction off" (Fig. 3 - position "0/OFF"
see inside front cover) and perform the
cleaning as you would with normal soiling.
The detergent liquid remains on the surface
to be cleaned and has time to settle in.
Move the vacuum bar lift pedal to position
"suction off" and reclean the surface.
Vacuuming in corners (BR 30/4 C Adv
only)
Pull the suction tube out toward the top,
attach the suction nozzle and vacuum
the dirt.
Remove the nozzle, replace the suction
tube and insert handle.

Complete cleaning

Turn off the water pump switch.
Push the appliance a little further to
vacuum up the remaining water.
Set main switch for brush/vacuum oper-
ation to "0".
Swivel the appliance handle forward
and arrest in the park position.
Disconnect the main plug from the
socket.
Emptying the Dirt Water Reservoir
Note
If the dirt water reservoir is full the float
closes the suction channel. The suction op-
eration is interrupted. Empty the dirt water
reservoir.
Warning
Please observe the local provisions regard-
ing the wastewater treatment.
Turn off the appliance.
Position the appliance upright and ar-
rest it in the park position.
Remove the fresh water reservoir from
the appliance.
Swivel support bow downward and re-
move the waste water reservoir.
Lift the lock and remove the lid of the
waste water reservoir.
Pour out dirt water.
The rinse the dirt water reservoir with
clear water.
Replace the lid of the waste water res-
ervoir and lock it.
Insert the waste water container into the
appliance.
EN
3
-
13