Connecting The Ultrasound System - FujiFilm Sonosite Edge Manual Para El Usuario

Connecting the ultrasound system

Attach the mini-dock if you use the system with AC-powered peripherals.
To attach the mini-dock
Note Make sure that the battery is installed before you attach the mini-dock.
1 Turn off the ultrasound system.
The mini-dock may not function properly if you connect the system while the power is on.
2 Place the mini-dock on the system platform.
3 Slide the mini-dock feet under the ultrasound system and firmly press the mini-dock into the I/O connector
on the back of the system.
The mini-dock is correctly attached when no gap is between the system and mini-dock.
See Figure 2.
Note If at any time the ultrasound system should lose connectivity, turn off the system
and reattach the mini-dock and system.
Always verify that the mini-dock and system are correctly attached after changing a transducer. When you
change a transducer, the mini-dock may loosen.
Mini-dock
Figure 2 System platform with system and mini-dock attached (H-Universal stand with M-Turbo system
shown).
Connecting the ultrasound system
System
System latch
5