Menu Navigation / Setting The Functions; Operating Mode Menu; Exposure Parameter Menu - Leica SF 58 Manual De Instrucciones

Menu navigation / setting the functions

All settings on the LEICA SF 58 are made via the menus and with help of the
four buttons 1.13, 1.14, 1.15 and 1.16 below the monitor (1.11). These buttons
assume different functions with different setting steps.
Their respective functions are always shown on the monitor, directly above the
individual buttons. In the starting position, after switching on the flash unit,
these are:
Mode
–

(1.13): Operating mode menu

Set
–

(1.14): Exposure parameter menu

Menu
– (1.15): Basic settings menu
– „ " (1.16): Hand release (for test flash)
Operating mode menu
After calling the menu by pressing the
flash operating modes available appears on the monitor, and the one activated is
identified by a black bar.
Simultaneously, the buttons change their function:
(1.13), (1.14): to select the operating modes in the list (second step)
Note:
The list is not an "endless loop", i.e. at the highest item, only the
ton can be used, at the lowest, only
Set
(1.15), (1.16): to confirm and activate the selected operating mode
(third step, both buttons can be used)
The display on the monitor returns to the starting
position.
1
Mode
button twice (first step), the list of
.
Exposure parameter menu
After calling the menu by pressing the
of the changeable parameters appears on the monitor.
Simultaneously, the buttons change their function:
Set
(1.14): for selecting the desired parameter by pressing several times if
necessary (second step)
– +
(1.15),
(1.13): to confirm and activate the selected setting(s) (fourth step).
The display on the monitor returns to the starting position.
but-
1 Pressing once switches on the monitor illumination (see p. 45).
46
1
Set
button twice (first step), the first
(1.16): to reduce or increase the parameter values
(third step)