Connecting A Transducer - FujiFilm SonoSite X-PORTE Guia De Inicio Rapido

a Connect the AC power cord, located in the accessory box, to the stand, and then connect the AC power
cord to a hospital-grade outlet. The battery will charge whenever the system is connected to AC power.
The location of the AC power cord socket may depend on the accessories that are installed on the system.
PowerPark installed
b Wheel the SonoSite X-Porte system backward into the PowerPark dock.
6 While connected to AC power, you can turn on the system and use it immediately. Before using the
system on battery power for the first time, be sure to charge the battery for a minimum of four hours.

Connecting a transducer

The Triple Transducer Connect (TTC) is a three-transducer module that lets you simultaneously connect up
to three transducers to the ultrasound system. The TTC is standard with the system.
Notes
To connect a transducer to the TTC
1 Pull the transducer latch up, and rotate it clockwise.
Connecting a transducer
No PowerPark
If the TTC is not installed on your system, you can connect one transducer directly
to the SonoSite X-Porte system.
11