Bodilink Head Support; Installation - Permobil "A" Mounting Block - Permobil BodiLink Serie Manual De Instrucciones

BodiLink Head Support

HS

INSTALLATION - PERMOBIL "A" MOUNTING BLOCK

Corpus (23"-28" height) and Corpus HD (24"-29" height) with UniTrack System
1 If the head support hardware stem (C) is inserted in the mounting block (B), turn the knob (A)
counterclockwise to release it. Remove the hardware stem; set aside.
2 Using the 5mm hex key, loosen but do not remove the screws (D) to create a gap between the
double nuts (E) and the mounting block (B).
3
Slide the double nuts (E) into the UniTrack System slots and move into position.
4
Tighten the screws (D) with the 5mm hex key to secure.
5
Insert the hardware stem (C) into the mounting block (B) and turn the knob (A) clockwise to secure.
IMPORTANT! Make sure that at least ½" (1.27cm) of the hardware stem is completely through the bottom of the mounting block (B)
at all times. See the warning in the "Important Safety Information" section in this manual.
Note: See SUPPORT PAD installation, positioning and adjustment instructions in this manual to make final adjustments.
B
1
BodiLink on Permobil Corpus Operation Manual
Track Slots
C
A
5
D
B
E
E
3
D