Service And Repairs - Leister WELDPLAST S1 Manual Del Usaurio

Maintenance
• Check power supply cord (13) and plug for electrical and mechanical damage.
• Clean the extruder nozzle (17) of welding residue every time the welding shoe is changed.

Service and Repairs

• Repairs should only be carried out by authorised Leister service points.
These guarantee a professional, reliable repair service within 24 hours, using original
replacement parts according to the circuit diagrams and replacement part lists.
• If the display «Maintenance servicing» appears after the WELDPLAST S1 device
is switched on, the drive motor (collector and carbon brushes) should be checked
by an authorized Leister service center and replaced if necessary. The display
disappears automatically after 10 seconds or can be directly skipped by pressing
the «Acknowledge» button (25)
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case of gu-
arantee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery document.
Heating elements shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
.
39